A brake conversion on a 1968 Firebird needs lines bent for the new hardware, not the old drums. This Right Stuff pre-bent stainless steel brake line kit covers the hard lines specific to this brake setup, made for the power front disc/rear drum conversion layout, bent on CNC equipment to follow the original routing.
Why It's Worth It
- Pre-bent to fit, so there's no tubing bender, cutting or flaring
- Bent on CNC benders with machine-formed flares for consistent ends
- Stainless steel resists corrosion and keeps a bright natural finish
- Steel tube nuts/fittings included
- Specific to the 1968 Firebird, not a universal roll of tubing
Before You Order
- This kit is for power front disc/rear drum conversion setups; other brake setups route differently and need a different kit
- Stainless is harder than mild steel, so tighten fittings carefully to seat the flares
- Replacing old rubber hoses at the same time is good practice
- Bleed the entire system after installation
Specifications:
| Material Option: |
Stainless Steel |
| Part Type: |
Brake Line Kit |
| Disclaimer: |
The image shows a representation of the part type. Actual part and fitment location may vary. |