The Right Stuff 69 Firebird Front Manual Drum Pre-Bent Stainless Steel Brake Line Kit - (FKT6902S)

Bending and flaring brake lines by hand on a 1969 Firebird eats a weekend and rarely looks factory. This Right Stuff pre-bent stainless steel front brake line kit covers the front section of the system, from the master cylinder area out to the front brake hoses, made for manual drum brakes, bent on CNC equipment to follow the original routing.

Why It's Worth It

• Pre-bent to fit, so there's no tubing bender, cutting or flaring
• Bent on CNC benders with machine-formed flares for consistent ends
• Stainless steel holds up to road salt and moisture far longer than mild steel
• Steel tube nuts/fittings included
• Specific to the 1969 Firebird, not a universal roll of tubing

Before You Order

• This kit is for manual drum brakes; other brake setups route differently and need a different kit
• Covers the front lines only; front-to-rear and rear axle lines are sold separately
• Stainless is harder than mild steel, so tighten fittings carefully to seat the flares
• Replacing old rubber hoses at the same time is good practice
• Bleed the entire system after installation

Specifications:

Material Option:	Stainless Steel
Part Type:	Brake Line Kit
Disclaimer:	The image shows a representation of the part type. Actual part and fitment location may vary.