On a 1953-54 Bel Air, the long front-to-rear brake line runs the length of the frame, exposed to road salt and water the whole way. This Right Stuff pre-bent line is made from stainless steel for the 1953-54 Chevrolet Bel Air, so the longest line on the car is also the one you won't have to replace again.
Why It's Worth It
- Stainless steel resists corrosion far better than plain steel lines
- Pre-bent to the factory front-to-rear route, so there's no long bending job under the car
- Made for the 1953-54 Chevrolet Bel Air
- Replaces a rusted original before it starts weeping
Before You Order
- Confirm your car still runs the factory single-circuit system; a dual master conversion changes the line layout
- Use new frame clips and replace the flex hoses at the same time
- Stainless is harder than steel, so tighten fittings carefully and check for leaks
- Bleed the full system after installation
Specifications:
| Material Option: |
Stainless Steel |
| Part Type: |
Brake Line |
| Disclaimer: |
The image shows a representation of the part type. Actual part and fitment location may vary. |