The Right Stuff 55-56 Chevy 3/4 Ton 2nd Series Shortbed Pre-Bent Stainless Rear Axle Brake Line - (TRA5701S)

Bending and flaring brake lines by hand on a 1955-1956 Chevy 3/4 Ton 2nd Series Short Bed eats a weekend and rarely looks factory. This Right Stuff pre-bent stainless steel rear axle brake line kit covers the lines on the rear axle housing that feed each rear wheel, so it goes in shaped and ready instead of bent in the garage. Why It's Worth It: Pre-bent to fit, so there's no tubing bender, cutting or flaring. Bent on CNC benders with machine-formed flares for consistent ends. Stainless steel holds up to road salt and moisture far longer than mild steel. Steel tube nuts/fittings included. Specific to the 1955-1956 Chevy 3/4 Ton 2nd Series Short Bed, not a universal roll of tubing. Before You Order: Specific to vehicles listed as Short Bed; confirm yours matches before ordering. Covers the rear axle lines only; confirm your axle type and rear brake setup. Stainless is harder than mild steel, so tighten fittings carefully to seat the flares. Inspect flex hoses and wheel cylinders/calipers while the system is open. Bleed the entire system after installation.

Specifications:

California Proposition 65:	Yes
Fittings Included:	Yes
Line Material:	Stainless Steel
Material Option:	Stainless Steel
Part Type:	Brake Line Kit
Pre-Formed:	Yes
Disclaimer:	The image shows a representation of the part type. Actual part and fitment location may vary.