The Right Stuff 65-68 Corvette Left & Right w/Armor Pre-Bent Stainless Rear Axle Brake Line Kit - (VRA6502S)

Bending and flaring brake lines by hand on a 1965-1968 Corvette Left & Right w/ Armor eats a weekend and rarely looks factory. This Right Stuff pre-bent stainless steel rear axle brake line kit covers the lines on the rear axle housing that feed each rear wheel, so the lines arrive shaped to the chassis and ready to install.

Why It's Worth It

• Pre-bent to fit, so there's no tubing bender, cutting or flaring
• Bent on CNC benders with machine-formed flares for consistent ends
• Stainless steel holds up to road salt and moisture far longer than mild steel
• Steel tube nuts/fittings included
• Specific to the 1965-1968 Corvette Left & Right w/ Armor, not a universal roll of tubing

Before You Order

• Specific to vehicles listed as w/ Armor; confirm yours matches before ordering
• Covers the rear axle lines only; confirm your axle type and rear brake setup
• Stainless is harder than mild steel, so tighten fittings carefully to seat the flares
• Replacing old rubber hoses at the same time is good practice
• Bleed the entire system after installation

Specifications:

Material Option:	Stainless Steel
Part Type:	Fuel Pump To Carb Line
Disclaimer:	The image shows a representation of the part type. Actual part and fitment location may vary.