Original brake lines on a 1967-1969 Mustang Boss 429 9" 31 Spline have usually seen decades of corrosion, kinks and old repairs. This Right Stuff pre-bent stainless steel rear axle brake line kit covers the lines on the rear axle housing that feed each rear wheel, so it goes in shaped and ready instead of bent in the garage.
Why It's Worth It
- Pre-bent to fit, so there's no tubing bender, cutting or flaring
- Bent on CNC benders with machine-formed flares for consistent ends
- Stainless steel holds up to road salt and moisture far longer than mild steel
- Steel tube nuts/fittings included
- Specific to the 1967-1969 Mustang Boss 429 9" 31 Spline, not a universal roll of tubing
Before You Order
- Covers the rear axle lines only; confirm your axle type and rear brake setup
- Stainless is harder than mild steel, so tighten fittings carefully to seat the flares
- Replacing old rubber hoses at the same time is good practice
- Bleed the entire system after installation
Specifications:
| Material Option: |
Stainless Steel |
| Part Type: |
Rear Axle Brake Line |
| Disclaimer: |
The image shows a representation of the part type. Actual part and fitment location may vary. |