Original brake lines on a 1967-1971 Ford F100 & F250 2WD have usually seen decades of corrosion, kinks and old repairs. This Right Stuff pre-bent stainless steel front brake line kit covers the front section of the system, from the master cylinder area out to the front brake hoses, bent on CNC equipment to follow the original routing.
Why It's Worth It
- Pre-bent to fit, so there's no tubing bender, cutting or flaring
- Bent on CNC benders with machine-formed flares for consistent ends
- Stainless steel holds up to road salt and moisture far longer than mild steel
- Steel tube nuts/fittings included
- Specific to the 1967-1971 Ford F100 & F250 2WD, not a universal roll of tubing
Before You Order
- Specific to vehicles listed as 2WD; confirm yours matches before ordering
- Covers the front lines only; front-to-rear and rear axle lines are sold separately
- Stainless is harder than mild steel, so tighten fittings carefully to seat the flares
- Replacing old rubber hoses at the same time is good practice
- Bleed the entire system after installation
Specifications:
| Bendable: |
Yes |
| California Proposition 65: |
Yes |
| Fittings Included: |
Yes |
| Line Material: |
Stainless Steel |
| Material: |
Stainless Steel |
| Part Type: |
Brake Line |
| Pre-Formed: |
Yes |
| Disclaimer: |
The image shows a representation of the part type. Actual part and fitment location may vary. |