Bending and flaring brake lines by hand on a 1967-1972 Ford F-100 2WD eats a weekend and rarely looks factory. This Right Stuff pre-bent stainless steel front brake line kit covers the front section of the system, from the master cylinder area out to the front brake hoses, made for manual drum brakes, so the lines arrive shaped to the chassis and ready to install.
Why It's Worth It
- Pre-bent to fit, so there's no tubing bender, cutting or flaring
- Bent on CNC benders with machine-formed flares for consistent ends
- Stainless steel resists corrosion and keeps a bright natural finish
- Steel tube nuts/fittings included
- Specific to the 1967-1972 Ford F-100 2WD, not a universal roll of tubing
Before You Order
- This kit is for manual drum brakes; other brake setups route differently and need a different kit
- Specific to vehicles listed as 2WD; confirm yours matches before ordering
- Covers the front lines only; front-to-rear and rear axle lines are sold separately
- Stainless is harder than mild steel, so tighten fittings carefully to seat the flares
- Replacing old rubber hoses at the same time is good practice
- Bleed the entire system after installation
Specifications:
| California Proposition 65: |
Yes |
| Fittings Included: |
Yes |
| Line Material: |
Stainless Steel |
| Material Option: |
Stainless Steel |
| Part Type: |
Brake Line Kit |
| Disclaimer: |
The image shows a representation of the part type. Actual part and fitment location may vary. |