The Right Stuff 68 Camaro & Chevy II (w/Mono Leaf Spring) Rear Axle Pre-Bent Stainless Brake Line - (FRA6802S)

If the hard lines on your 1968 Camaro & Chevy II (w/ Mono Leaf Spring) are rusted, kinked or patched, this is the clean fix. This Right Stuff pre-bent stainless steel rear axle brake line kit covers the lines on the rear axle housing that feed each rear wheel, bent on CNC equipment to follow the original routing.

Why It's Worth It

• Pre-bent to fit, so there's no tubing bender, cutting or flaring
• Bent on CNC benders with machine-formed flares for consistent ends
• Stainless steel holds up to road salt and moisture far longer than mild steel
• Steel tube nuts/fittings included
• Specific to the 1968 Camaro & Chevy II (w/ Mono Leaf Spring), not a universal roll of tubing

Before You Order

• Specific to vehicles listed as w/ Mono Leaf Spring) Rear Axle; confirm yours matches before ordering
• Covers the rear axle lines only; confirm your axle type and rear brake setup
• Stainless is harder than mild steel, so tighten fittings carefully to seat the flares
• Replacing old rubber hoses at the same time is good practice
• Bleed the entire system after installation

Specifications:

Material Option:	Stainless Steel
Part Type:	Rear Axle Brake Line
Disclaimer:	The image shows a representation of the part type. Actual part and fitment location may vary.