The Right Stuff 76-77 Bronco w/Dana 44 Front Pre-Bent Stainless 5 Piece Front Brake Line Kit - (TKT4704S)

If the hard lines on your 1976-1977 Bronco w/ Dana 44 are rusted, kinked or patched, this is the clean fix. This Right Stuff 5-piece pre-bent stainless steel front brake line kit covers the front section of the system, from the master cylinder area out to the front brake hoses, so it goes in shaped and ready instead of bent in the garage. Why It's Worth It: Pre-bent to fit, so there's no tubing bender, cutting or flaring. Bent on CNC benders with machine-formed flares for consistent ends. Stainless steel holds up to road salt and moisture far longer than mild steel. Steel tube nuts/fittings included. Specific to the 1976-1977 Bronco w/ Dana 44, not a universal roll of tubing. What's Included: 5-piece pre-bent stainless steel brake line set with fittings. Before You Order: Specific to vehicles listed as w/ Dana 44 Front; confirm yours matches before ordering. Covers the front lines only; front-to-rear and rear axle lines are sold separately. Stainless is harder than mild steel, so tighten fittings carefully to seat the flares. Replacing old rubber hoses at the same time is good practice. Bleed the entire system after installation.

Specifications:

Bendable:	Yes
California Proposition 65:	Yes
Fittings Included:	Yes
Line Material:	Stainless Steel
Material:	Stainless Steel
Material Option:	Stainless Steel
Materials:	Stainless Steel
Part Type:	Brake Line
Pre-Formed:	Yes
Disclaimer:	The image shows a representation of the part type. Actual part and fitment location may vary.