The Right Stuff 95 Chevy S10 Rear Disc 2 Piece Pre-Bent Stainless Steel Rear Axle Brake Line - (TRA9502S)

Bending and flaring brake lines by hand on a 1995 Chevy S10 eats a weekend and rarely looks factory. This Right Stuff 2-piece pre-bent stainless steel rear axle brake line kit covers the lines on the rear axle housing that feed each rear wheel, made for disc brakes, so it goes in shaped and ready instead of bent in the garage.

Why It's Worth It

• Pre-bent to fit, so there's no tubing bender, cutting or flaring
• Bent on CNC benders with machine-formed flares for consistent ends
• Stainless steel holds up to road salt and moisture far longer than mild steel
• Steel tube nuts/fittings included
• Specific to the 1995 Chevy S10, not a universal roll of tubing

What's Included

• 2-piece pre-bent stainless steel brake line set with fittings

Before You Order

• This kit is for disc brakes; other brake setups route differently and need a different kit
• Covers the rear axle lines only; confirm your axle type and rear brake setup
• Stainless is harder than mild steel, so tighten fittings carefully to seat the flares
• Replacing old rubber hoses at the same time is good practice
• Bleed the entire system after installation

Specifications:

Material Option:	Stainless Steel
Part Type:	Rear Axle Brake Line
Disclaimer:	The image shows a representation of the part type. Actual part and fitment location may vary.