Converting a 1968 Chevelle/El Camino w/ Manual Disc to manual disc brakes means the factory line routing no longer works. This Right Stuff pre-bent stainless steel front brake line kit covers the front section of the system, from the master cylinder area out to the front brake hoses, made for the manual disc conversion layout, so it goes in shaped and ready instead of bent in the garage.
Why It's Worth It
- Pre-bent to fit, so there's no tubing bender, cutting or flaring
- Bent on CNC benders with machine-formed flares for consistent ends
- Stainless steel resists corrosion and keeps a bright natural finish
- Steel tube nuts/fittings included
- Specific to the 1968 Chevelle/El Camino w/ Manual Disc, not a universal roll of tubing
Before You Order
- This kit is for manual disc conversion setups; other brake setups route differently and need a different kit
- Specific to vehicles listed as w/ Manual Disc Conversion; confirm yours matches before ordering
- Covers the front lines only; front-to-rear and rear axle lines are sold separately
- Stainless is harder than mild steel, so tighten fittings carefully to seat the flares
- Replacing old rubber hoses at the same time is good practice
- Bleed the entire system after installation
Specifications:
| Material Option: |
Stainless Steel |
| Part Type: |
Brake Line Kit |