Brake lines are easy to overlook until one weeps or rusts through, and on a 1974 Dodge 1/2 Ton 2WD the originals are long overdue. This Right Stuff pre-bent stainless steel brake line kit covers the hard lines specific to this brake setup, bent on CNC equipment to follow the original routing.
Why It's Worth It
- Pre-bent to fit, so there's no tubing bender, cutting or flaring
- Bent on CNC benders with machine-formed flares for consistent ends
- Stainless steel holds up to road salt and moisture far longer than mild steel
- Steel tube nuts/fittings included
- Specific to the 1974 Dodge 1/2 Ton 2WD, not a universal roll of tubing
Before You Order
- Specific to vehicles listed as 2WD; confirm yours matches before ordering
- Stainless is harder than mild steel, so tighten fittings carefully to seat the flares
- Replacing old rubber hoses at the same time is good practice
- Bleed the entire system after installation
Specifications:
| Material Option: |
Stainless Steel |
| Part Type: |
Brake Line Kit |
| Disclaimer: |
The image shows a representation of the part type. Actual part and fitment location may vary. |