If the hard lines on your 1976 Dodge 1/2 Ton 4WD are rusted, kinked or patched, this is the clean fix. This Right Stuff pre-bent stainless steel rear axle brake line kit covers the lines on the rear axle housing that feed each rear wheel, bent on CNC equipment to follow the original routing.
Why It's Worth It
- Pre-bent to fit, so there's no tubing bender, cutting or flaring
- Bent on CNC benders with machine-formed flares for consistent ends
- Stainless steel resists corrosion and keeps a bright natural finish
- Steel tube nuts/fittings included
- Specific to the 1976 Dodge 1/2 Ton 4WD, not a universal roll of tubing
Before You Order
- Specific to vehicles listed as 4WD; confirm yours matches before ordering
- Covers the rear axle lines only; confirm your axle type and rear brake setup
- Stainless is harder than mild steel, so tighten fittings carefully to seat the flares
- Replacing old rubber hoses at the same time is good practice
- Bleed the entire system after installation
Specifications:
| Material Option: |
Stainless Steel |
| Part Type: |
Rear Axle Brake Line |
| Disclaimer: |
The image shows a representation of the part type. Actual part and fitment location may vary. |